DIY Jenga Keychain


Here’s what you’ll need:- Wooden blocks
– Decorative paper (scrapbook page, map, sheet music, pretty wrapping paper, pages of a book, ect…)
– Screw eye
– Key ring
– Round nose pliers
– Mod Podge
– Brush
– Pencil
– Scissors

Use the pliers to screw the screw eye into the top of the block.
Trace the sides of the block on to the paper and cut them out. I cut mine slightly smaller so that I could have a nice wooden border around each paper.

Apply a thin layer of Mod Podge to the back of each paper and place them on the Jenga block. Make sure to smooth out the paper to prevent air bubbles.

Allow a few minutes to dry completely and then apply a thin layer of Mod Podge around all the sides. It will go on white but dies clear and provodes a protective seal.

 Now just attach the key ring, throw on a few keys and admire your lovely new keychain!

So many possibilities… What are you going to put on yours?

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: